This filler is designed to dose fill dry loose or piece products by weighing out set doses with their further discharge. It features a higher capacity in comparison with one-lane filler.
Filler runs in a stepwise cyclic mode and is controlled by weighing terminal microcomputer.
All operation data can be seen on a display unit.
This two-lane weighing filler can run together with packaging machines Pitpack, Pitpack Smart, Pitpack M, Pitpack M2 or as an independent unit.
The following products can be handled: Macaroni,
ravioli, biscuits, granulated sugar, salt, cereals, etc.
Performance specification: |
Kinematical speed, max:
(to be specified for each product) |
15...35 portions/min |
Dose weight, max: |
2 kg |
|
| Dry loose products |
Standard accuracy required by Russian state norms |
Small piece products
(depends on capacity and kind of handled products) |
1...2 fractions |
Air system pressure: |
0.6 MPa |
| Air consumption: |
40 L/min |
Power supply: |
220 V; 1-phase; 50 Hz |
| Power consumption: |
0.6 kW |
| Overall dimensions: |
| length |
1,120 mm |
| width |
1,245 mm |
| height |
910 mm |
Weight: |
200 kg |
- Feeding tank and framework;
- Coarse and fine weighing vibrating chutes;
- Load cell unit with a weighing bin;
- Set of sensors to control products level;
- Control system.
Products to be weighed are poured from a feeding tank into two upper vibrating chutes; from where they come down to the coarse and fine weighing chutes.
Products from a coarse weighing vibrating chute come to a weighing bin and are accumulated there to reach specified weight. Then, fine weighing chute gradually adds products until a target weight is achieved. Fine weighing chute gate closes and products are discharged from a weighing bin through an intermediate hopper into a packaging machine products pipe for packaging.
| 
