This filler is designed to dose fill dry loose or piece products by weighing out set portions with their further discharge. It features a higher capacity in comparison with two-lane filler.
Filler runs in a stepwise cyclic mode and is controlled by weighing terminal microcomputer.
All operation data can be seen on a display unit.
This three-lane weighing filler can run together with packaging machines Pitpack Smart, Pitpack M, Pitpack M2 or as an independent unit.
The following products can be handled: Macaroni,
ravioli, biscuits, granulated sugar, salt, cereals, etc.
Performance specification: |
Kinematical speed, max:
(to be specified for each product) |
65 portions/min |
Dose weight, max: |
2 kg |
|
| Dry loose products |
In conformity with Russian state norms and standards |
Small piece products
(depends on capacity and kind of handled products) |
1...2 fractions |
Air system pressure: |
0.6 MPa |
| Air consumption: |
60 L/min |
Power supply: |
220 V; 1-phase; 50 Hz |
| Power consumption: |
1.5 kW |
| Overall dimensions: |
| length |
1,920 mm |
| width |
1,765 mm |
| height |
1,480 mm |
Weight: |
230 kg |
- Feeding tank and framework;
- Coarse and fine weighing vibrating chutes;
- Load cell unit with a weighing bin;
- Set of sensors to control products level;
- Control system.
Products to be weighed are poured from a feeding tank into three upper vibrating chutes; from where they come down to the lower coarse and fine weighing chutes.
Products from a coarse weighing vibrating chute come to a weighing bin and are accumulated there to reach specified weight. Then, fine weighing chute gradually adds products until a target weight is achieved. Fine weighing chute gate closes and products are discharged from a weighing bin through an intermediate hopper into a packaging machine products pipe for packaging.
| 
